Modulated rate – dependent strain hardening of Ag/Bi2223

科学技術人材育成費補助金 テニュアトラック普及・定着事業
Modulated rate – dependent strain hardening of Ag/Bi2223
composite wire with a low – strength AgMg alloy matrix
講師:Dr.
講師: Malik Idries Adam(
(Universiti Tenaga Nasional, Malaysia)
)
主催:サステナブル・ディベロップメント実践研究センター
日時:平成26
日時:平成26年
26年3月26日(
26日(水
日(水)11時~
11時~12
時~12時
12時
場所:先端物質科学研究科
場所:先端物質科学研究科 402N号室
402N号室
The strain hardening and the pre-compressive forces exerted on the ceramic filaments in Ag/Bi – 2223
composite wire is analysed and discussed in detail. Tensile stress–strain,
, hardening – relaxation
, and transport current
analysis were carried out on specimens from the wire at 77 K.
Strain hardening analysis is controlled such that the applied stress is released at the stress value
normally used for the calculation of the composite modulus of elasticity. A biexponential model is
employed to further analyse the relaxation data. Two well separated decaying parameters indicate
that there are two competing mechanisms in the composite wire. We relate this behaviour to elastic
relaxation in the metal matrix whereas the Bi – 2223 filaments relax through microscopic length
reduction when the composite wire is in the elastic state of deformation. However, when the
composite experiences plastic deformation, plastic flow in the low – strength metal matrix
accompanied by successive fracture in the ceramic filaments was found. Since there was no
systematic transition in the deformation states of the wire,
data were further analysed by a rate
– dependent power – law hardening of the Ramberg – Osgood type. The enormous effect of the strain
hardening has manifested in a hysteretic form of strain rate distribution over the flow range where
the stress on the composite is found to repetitively buckle down to about 96%. The highest attainable
residual strain is therefore used to estimate the intrinsic strain in Bi – 2223 filaments when the precompressive stress is completely depleted.
Dr. M I. Adam currently works as a Senior Lecturer at the Department of Mechanical
Engineering, Universiti Tenaga Nasional, UNITEN in Malaysia. He received his PhD in
Magnetic Materials & Superconductors from University Putra Malaysia in 2003. In 2004 –
2005 he was a post doctoral research fellow at the Department of Materials Science and
Engineering, Kyoto University, Japan. His previous employers include University of
Technology PETRONAS, University Putra Malaysia, and University of Malaya in Malaysia.
His research interests lie in the domain of electro – active ceramics which includes
superconductivity, magnetoelectricity, and multiferroicity. He is also interested in modeling
and simulation of the physics behind these exotic materials.
URL: http://www.researcherid.com/rid/F-4050-2011
Attention! This talk will be in English 講演は英語、質疑は日本語も可能です
講演は英語、質疑は日本語も可能です